Model CPIT Impact Model Pin Brinell

The Pin Brinell uses a calibrated shear pin to control the amount of load applied. After the impression is made the width is measured and the value converted to an equivalent Brinell number.

• Consistent loading regardless of operator.
• Test without clamping - access is only needed to one side of a test specimen.
• Tests in 100 - 730 equivalent Brinell range (higher hardness requires a carbide tip indenter
• Faster and easier than the impact bar method.
• Many thousands sold

Model CPST C-Clamp Model Pin Brinell

The C-clamp Version of the Pin Brinell comes in a kit with the CPIT. A stand is available for using the CPST as a bench unit.

• Useful for testing smaller parts, smaller diameter rounds, and unsupported parts.
• Tests parts up to 6" in diameter
• Accuracy to +/- 1% of load applied